Service 03 · Deep foundations

Auger cast piles

An auger cast pile is a deep foundation formed by drilling a continuous hollow-stem auger to depth and pumping grout through the stem as the auger is withdrawn, so the hole is never left open. The steel goes in last, pushed into the wet grout.

Finished piles with the steel standing up on an MTR job site

How is an auger cast pile built?

  1. The rig sets up over the pile location from the layout.
  2. The hollow-stem auger is drilled to the design depth on the plans. While drilling, the soil-filled flights support the hole.
  3. Grout is pumped under pressure down the stem and out of the auger tip as the auger is pulled back up, so the hole fills from the bottom as the auger leaves it.
  4. The reinforcing cage or bar is pushed down into the wet grout before the grout begins to stiffen.
  5. Grout volume, pressure and auger withdrawal are recorded for each pile, as specifications typically require, because the grout goes in out of sight.

When are auger cast piles used?

They are often chosen because they install quickly, with less noise and vibration than driven piles, which matters next to neighbors’ homes and on tight residential lots.

Whether they suit a particular site depends on the loads, the soil and rock, the groundwater and the schedule. The geotechnical engineer recommends the foundation type and the structural engineer of record designs it.

Auger cast piles in Miami limestone

Much of Miami-Dade sits on porous limestone with groundwater close to the surface. Where the auger meets a void, grout flows into it, so a pile can take more grout than its theoretical volume. Recording grout volume against depth on every pile shows where that happened, and the engineer decides whether any action is needed.

What do we need to quote auger cast piles?

  • The foundation plans and the pile or hole schedule (number, diameter and depth).
  • The geotechnical report with its boring logs, if there is one.
  • The job site city or ZIP, and anything that limits access: overhead lines, neighbors, room for the rig and trucks.
  • When you need us on site.

Frequently asked questions

Is an auger cast pile the same as a CFA pile?

Largely, yes. FHWA covers augered cast-in-place piles under continuous flight auger (CFA) piles, and in US practice the terms are often used interchangeably.

When does the steel go into an auger cast pile?

Last. The auger drills to depth, grout is pumped through its hollow stem as it is withdrawn, and the reinforcing cage or bar is then pushed down into the wet grout.

Can auger cast piles be used below the water table?

Often, yes. The grout is pumped through the hollow stem and fills the hole from the bottom up as the auger is withdrawn. Whether they suit a particular site is the engineer’s decision.

Who decides whether a building gets auger cast piles?

The geotechnical engineer recommends foundation types from the site investigation, and the structural engineer of record designs the foundation shown on the plans. We build what the plans call for.

Sources

Get a quote

Got plans? Let’s drill.

Send the foundation plans and the soil report, or just call and tell us about the job.