Service 01 · Deep foundations

Auger holes

An auger hole is an open hole drilled with an auger to the diameter and depth on the plans. The spoil comes up the auger flights and out of the hole. What goes into the hole, and when, is set by the plans.

A drilled hole on an MTR job site

How is an auger hole drilled?

  1. The hole locations are laid out from the plans.
  2. The rig sets up over each mark and drills to the diameter and depth shown on the plans.
  3. Spoil comes up the auger flights and out of the hole.
  4. The hole is measured against the plans before the next step.
  5. The next step follows the plans: for example steel, concrete or posts.

What are auger holes used for?

It depends on the plans. Common uses include footings, piers and post foundations. The engineer of record sets the diameter, the depth and what goes into the hole.

Will the hole stay open?

That depends on the soil and the groundwater. Loose or sandy ground, and holes that reach the water table, can cave. The plans and the geotechnical report set how the hole is supported and how soon the next step follows.

What happens to the spoil?

It comes up the auger flights and out of the hole. How it is handled on site or hauled off is part of the job scope we quote.

What do we need to quote auger holes?

  • The foundation plans and the pile or hole schedule (number, diameter and depth).
  • The geotechnical report with its boring logs, if there is one.
  • The job site city or ZIP, and anything that limits access: overhead lines, neighbors, room for the rig and trucks.
  • When you need us on site.

Frequently asked questions

Is an auger hole the same as a drilled shaft?

Not necessarily. A drilled shaft is a specific engineered foundation: a bored hole with a steel cage and concrete placed to the shaft specifications. An auger hole is the drilled hole itself, sized and used as the plans call for.

What decides the diameter and depth of an auger hole?

The plans. The engineer sets them from the loads and the soil report, and we drill to what is shown.

Do I need a soil report for auger holes?

Your engineer decides. A geotechnical report, where there is one, shows what the hole will be drilled through, such as loose sand, rock or water, and helps plan and price the work.

Get a quote

Got plans? Let’s drill.

Send the foundation plans and the soil report, or just call and tell us about the job.